![]() ![]() ![]() ![]() The most likely explanation is that Docker waits for some docker command before fully initializing and starting containers. └─3135 /usr/bin/dockerd -H fd:// -containerd=/run/containerd/containerd.sock rvice - Docker Application Container EngineĪctive: active (running) since Sun 08:33:23 PST 1h 25min ago.On a system where "docker ps" had been run with no other Docker commands, I got the following: Loaded: loaded (/lib/systemd/system/rvice disabled vendor preset: enabled)Īctive: inactive (dead) TriggeredBy: rvice - Docker Application Container Engine. ![]() On a system where no docker commands had been run, this command reported the following: Next I tried the command "systemctl status docker". I was surprised as I expected that command to just report some status information. After the system was booted, a container with a restart policy of "unless-stopped" would not restart automatically unless I typed a command that used docker in some way such as "docker ps". 56" Phantom Power: +12 VDC on pins 1 and 3 of MIDI IN jack MIDI signals recocnized: Program Change with MIDI Channel Size: 17" x 1.I have a similar issue running Linux systems. SPECIFICATIONS Jacks: 14 1/4" phone TRS jacks MIDI ports: 5-pin DIN IN and Through jacks Display: 2-digit high efficiency red. It will provide you with all the information you need to operate this device properly. Please take a moment to read this Owner's Manual carefully. This unit is designed as a MIDI Controllable audio and signal switcher. TABLE 3 TEST MODE COMMANDS AND DISPLAY LED MIDI COMMAND 1st Display 2nd Display Loop 1 Note Off Channel Number Note Number Loop 2 Note On Channel Number Note Number Key Loop 3 Pressure Channel Number Note Number Control Loop 4 Change Channel Number Control Number Program Switch 4 Change Channel Number Program Number Channel Switch 3 Pressure Channel Number Pressure Value Switch 2 Pitch Wheel Channel Number Not Used Switch 1 System Messge SE or SC or RT Not Used RFX Salt Lake City, UT RP93s PATCHWORK MIDI CONTROLLED AUDIO SWITCHER Thank you for your purchase of the RP93s Patchwork. Table 3 shows which MIDI commands and their status. Hold the UP and DOWN buttons while switching the power on. To enter Test Mode, first make sure the RP93s power is off.MIDI TEST MODE The RP93s has the ability to display the MIDI information present at the MIDI IN jack. Connect pin 1 to circuit ground, and pin 3 to +9 - +15 VDC of the receiving unit. We supply this note for those adventurous people who may want to give it a try. Many MIDI devices can be modified to supply power down the cable, but of course RFX makes no warranty to anyone as to the applicability of this modification or any damage that might be done as a result thereof. MIDI receivers supply 12 VDC on pins 1 and 3, and transmitters receive power on those same pins. RFX MIDI PHANTOM POWER Inspired by an article in the December 1989 issue of Electronic Musician (by Craig Anderton), we decided to emulate their MIDI phantom power model for RFX equipment. Note: Any settings that have not been stored will be lost. To return to normal operation mode, press and hold the UP and DOWN buttons again (same as entering Learn Mode) for 5 seconds.The RP93s will remain in Learn Mode after the default settings have been restored. The display will show FP during the reset operation. To restore the factory presets, press and hold Switch 1 and Switch 2 simultaneously for 5 seconds.To return to programming the Program Numbers, press the UP or DOWN buttons until the Program Numbers are again displayed.To enable the setting you have chosen, press the STORE button. ![]()
0 Comments
Leave a Reply. |